Soluzioni

OLY STEEL 2000 G

OLY STEEL 2000 G is a unidirectional steel fiber fabric with a total weight of 2000 g/m² with high resistance specific for structural consolidation works.

OLY STEEL 2000 G guarantees excellent tensile strength characteristics, allows you to easily remedy precarious situations affecting both vertical structures and horizontals, allowing, unlike interventions made with traditional materials, reduced invasiveness, as they allow to maintain almost the dimensions of the previous elements and their own weight and therefore of the entire structure remain unchanged. OLY STEEL systems have undoubted advantages: very high tensile strength, low specific weight, high resistance to environmental stress. Furthermore, they have the advantage of being applicable quickly and minimally invasively. The suitably installed reinforcement can subsequently be plastered with traditional plasters on the market.

  1. Demolition of the existing plaster until reaching the surface for the portion to be reinforced;
  2. Thorough cleaning of dusts, oils and paints of the support on which the reinforcement system must be applied;
  3. Washing and wetting of the surface until saturation;
  4. Application of a first layer of OLY WALL STRUKTURA-F type mortar with a trowel or spray with a suitable plastering machine, following the instructions given in the respective technical data sheets;
  5. Application on the previous “fresh” layer of mortar of the OLY STEEL 2000 G mesh, taking care to ensure an overlap between adjacent strips of at least 15 cm;
  6. Application of a second layer of OLY WALL STRUKTURA-F type mortar with a trowel or spray with a suitable plastering machine, following the instructions given in the respective technical data sheets. The total thickness of the mortar must be included, in the case of a single mesh, between 5 and 15 mm, net of the leveling of the substrate. In the case of several nets, the maximum thickness cannot exceed 30 mm.

Note: in the case of reinforcement on a single face of masonry or on two faces but in the presence of sack walls or facing that are not connected or not properly connected, it is necessary to use connectors from the OLYMPUS line at the rate of 2-4 connectors per m2.

  1. Demolition of the existing plaster until reaching the surface for the portion to be reinforced;
  2. Thorough cleaning from dust, oils and paints of the support on which the reinforcement system is to be applied;
  3. Apply the OLY RESIN PRIMER (A + B) primer on the surfaces subject to the reinforcement following the instructions in the relevant technical sheet;
  4. Apply a layer of OLY RESIN 10 (A + B) on the “fresh” primer following the instructions in the relative technical data sheet;
  5. Installation of the OLY STEEL 2000 G fabric with fibers oriented as per the project, taking care to ensure an overlap between adjacent strips of at least 15 cm;
  6. Apply a second layer of OLY RESIN 10 (A + B) “fresh”;
  7. Carry out a manual dusting with quartz sand on the still “fresh” system to increase the useful surface of adhesion for the subsequent laying of civil plaster.

Note: in the case of reinforcement on a single face of masonry or on two faces but in the presence of sack walls or facing that are not connected or not properly connected, it is necessary to use connectors from the OLYMPUS line at the rate of 2-4 connectors per m2.

The fabric is available in rolls of 50 m, standard length between 10 cm and 30 cm.